18W LED Downlight SMD 3014

Product Series Number:CL5013CW3014-18W(CW/PW/NW/WW)  Power Consumption:  18W LED Light  Luminance Flux:  1512 lm  Size of Down light:  Dia224xH 52.5mm  Color-rendering Index:  >85ra  LED Type:  SMD 3014  Power Dismiss:  ≤10%  LED Quantity:  180 pcs  Power Factor:  ≥95%  Material:  PC+Aluminum  Environment temperature  -20~50℃  Input Voltage:  AC85-265V  Warranty:  3 Years  Colour Temperature:  WW:2700-3200K  Installation Hole Size:  dia205±5mm  NW:4000-4500K  W.G./pc:  0.73kg/pcs  PW:5000-5500K  Pcs/ctn:  16pcs/ctn(47x38x47.5cm)  CW:6000-6500K  Unit packing size:   23x23x9.5cm

Features:
1. CE, RoHS certificate;
2. Low power consumption, save up to 80% energy than the traditional lamp;
3. Long life span, up to 50,000 hours;
4. No fluorescent flicking and buzzling, instant light up;
5. No hazard of mercury or lead emitting;
6. No rf interference;
7. Strong aluminum house, hard to be broken;
8. Better circuit power design than fluorescent tube, stable and safe.

Applications:
This 18W LED Downlight can be widely applied in places such as drinkery, hotel, hall, chamber, villa and other slap-up locations to illuminate and decorate. It can also can be used as store revelation, showcase, restaurant and other indoor decorations and lighting; revelation hall, art hall, museum, office, reading room and local lighting; groggery, karaoke and other entertainment places atmosphere lighting; Jewelry, gold and silver jewelry and fashion lighting.

LED Downlight Inatallation:

Decide where you wish to place your chosen downlights measuring out the ceiling and marking the central point of the light. Now drill a small pilot hole through the ceiling.

Now you have marked out the positions of the downlights it is a good idea to check above the ceiling to ensure that there are no joists / wires / pipes in the way. You should be able to see a small pinprick of light coming through the ceiling where you drilled the pilot holes. If you are unable to view the ceiling from above it gets trickier. The best way is to determine which way the joists run and what the spacing of them are. You could then use an old wire coat hanger bent at a 900 angle to the width of the downlight. Insert the wire through the hole until the 900bend is through. Now twist the wire a full 3600 and hopefully it will not bump into any obstructions.

In the instructions or on the box of the downlights it will say what the cut-out for that downlight will be. For the best results I will generally use a hole saw (a type of drill bit) to the correct size of the downlight which can be purchased very cheaply from most DIY stores. Alternatively the use of a plasterboard saw (Pad Saw) can be used which eliminates the need for a drill and hole saw. For this method you will need to draw a circle on the ceiling to the correct size as a guide for when you start to saw.

Hopefully now you have produced a clean cut hole in the ceiling, got the plaster out of your eyes and shaken yourself outside to stop you looking like Casper the ghost!

Once the wiring has been pulled through the hole the downlight can be wired. To fit the downlight into the hole hold the two springs back against the sides of the downlighter and push up into the hole. The springs then lie flat on the top of the ceiling holding it in place